COAXIAL (RF) Protectors
You May Also Be Interested In:
antenna lightning protector
TD*xxxxx64M/W (* for connector type) series antenna lightning protector are designed for protection of antenna coaxial device and receive/transmit system, avoid destruction result from lightning over-voltage, induced over-voltage and static discharge.
Large discharge current;
Wide working frequency range, DC pass
Low insertion loss and voltage standing wave rate (VSWR) ;
Stabile capability, good credibility
Working frequency range
Continuous operating voltage Uc
Nominal discharge current In
Max. Discharge Current Imax
Protection level Up 8/7005s
Notice: A. Connector type and it's corresponding SPD size is as following, ( In and Imax of SMA connector is half of the above data. )
Temperature -25~+65, Humidity relative<=95% (25)
Reserve the right for technology revises
Notice: A, # represent for different input/output type, meaning shows as follows:
Connect the protectors in series to the antenna circuit, and the protector should be closed to the equipment as much as possible.
Make connection lead as short as possible (lead section area not more then 2. 5mm2) , and another port connect protector with grounding bar reliably.
Using outdoors must avoid rainwater immerging into the protector to erode the inner components.
No special maintenance needed. When malfunction occurs in operating system, remove protector, and check the system. If system recovers, it means the protector has been damaged and must be replaced.