Coaxial Connections Series Signal Protectors
You May Also Be Interested In:
Coaxial Connections series signal protectors are designed for protection of communication network circuits, which are sensitive to electromagnetic interference, avoid destruction result from lightning over-voltage, induced over-voltage and static discharge.
Multi-Protection circuits, low residual voltage.
Large discharge current and quick response.
Superior transmission performance.
Excellent technics and long life even in bad circumstance
Continuous operating voltage Un
Nominal discharge current (8/205s) In
Max. discharge Current (8/205s) Imax
Protection level Up
Output Voltage threshold at 1kV/5s
Adapt transmission rate
Humidity relative<=95% (250) , Altitude<=3km
* for connector type:
＃ for I/O mode:
Male / Male
Male / Female
Female / Female
Female / Male
Connect in series between protected equipment and signal channels. Should install close to the protected equipment
Connect IN-port to signal channels and OUT-port to protected equipment.
Connect lead to grounding bar dependably.
No special maintenance needed. If malfunction occurs in operating system, please remove the protector, and then check the system. If system recovered, that means the protector has been damaged and must be replaced.