DISPERSE DYES PRINTING SYNTHETIC THICKENER FS-60
You May Also Be Interested In:
rotary screen printing
DISPERSE DYES PRINTING SYNTHETIC THICKENER FS-60:
Powerfull electrolyte resistance
Sharp printing effect and excellent color yield
Suitable for both flat and rotary screen printing
THICKENING AGENT FS-60
This thickening agent is used in disperse dyes printing with the effect of extra fine pattern and colors.
Completely taking the place of sodium alginate, no need to add any addition agents such as urea.
Of high deep-dyeing and high permeability, especially applying to close-mesh printing.
Good mesh permeability and close-mesh printing is excellent.
High resolution, no flushing and breaking while thin line printing.
Good uniform printing, no color spot and thread bare while large square printing.
The printing level is equal to cylinder steamer while continually ageing or thermal ageing.
Color yield and brightness are obviously higher than any other natural thickening agent.
Easy to desizing. It cant get mildew and thinning during storage.
Printing cost is obviously lower than sodium alginate.
Appearance:straw color crystalloid thick liquid.
pH value 6.510.5
Dynamic viscosity 1000-1250mPa. s
Take 4-8% of FS-60 and add the needed dyes and mix it with water uniformly.
1. White paste preparation
2. Color paste preparation
white paste 30-80
disperse dyes X
water total quantity up to 100
(I) Light color: FS-60 4%
Medium-dark: FS-60 6-8%
(II) Printing, coloring and washing in the above two ways are of the same technology as sodium alginate.
(III) Because of good mesh permeability, choosing the bolting cloth as high mesh number as possible when printing as to save the color paste and to enhance the printing efficiency.
(IV) Continuously ageing can shorten color fixing time comparing with sodium alginate and the
level of hand handle is close to that of cylinder steamer.
(V) Some dyes (such as C. I. Disperse Red 73) may cause FS-60 dilution, in order to adjust the
viscosity, more FS-60 should be put into use.
Package and storage:
Be packed in plastic casks of 50kg with well-closed package of plastic bag inside. This products should be kept in shady, cool and dry places, with temperature above 00. It should be used up within six months.
The above information is approved. Due to the different technology applied in different mill, the customers should make sure to take the right processing before using them.