Paint - Exterior Paint (Solarscreen)
You May Also Be Interested In:
Solarscreen is a smooth, even, opaque, low sheen finish which has enhanced resistance to ultra violet light and which will resist the effects of weather change. It is a durable, water based, 100% acrylic finish suitable for a wide range of exterior building materials. High quality grade raw materials have been used in its formulating to provide outstanding performance.
Provides a total latex system, offering excellent resistance to blistering on new construction
Excellent adhesion even over chalky surfaces
Screens out harmful UV rays
Easy to apply
Type: 100% Acrylic
Flash Point: Non Flammable
Gloss Level: Approximately 20% measured at 600
Solvent Resistance: Moderate when fully cured
Alcohol Resistance: Good when fully cured
Volume Solids: Approximately 35%
Thinning: Up to 15% with water if required
Drying Times: Touch dry - 30 minutes; Recoat - After 2 hours
Temperature Range: 100 - 350
Coverage: Approximately 5-6 square meters per litre depending upon texture and surface condition
Colors: Refer to the appropriate WARATAH color card. Colors customer requires are also available
Package: 20L / Drum
Storage: 18 months in cool and dry place
Remove grease, dust and dirt by washing down with a liquid detergent and warm water followed by a rinse with clean water. Allow to dry. All loose, peeling and flaking material must be removed. Sand the surface smooth until all gloss is removed. Fill holes and cracks with a spackling compound and sand lightly to an even finish.
Previously Painted Surfaces: Over old oil-based enamels use Waraprime undercoat. Over properly prepared water-based finishes no undercoat is required.
Paper-faced Plasterboard: No undercoat or sealer required. Absorbent plaster joints should have a preliminary coat of Waratah Solarscreen before coating the entire surface.
Plaster Glass, Fibrous Plaster and Set Hard Plaster: Apply one coat of Waratah Solarscreen primer.
Unpainted Brick, Cement Render, Stone, Fibre Cement: Ensure that new cement or concrete work is fully cured before applying Waratah Solarscreen. Alternatively, one coat of Waratah Waraprime may be supplied.
Stir contents thoroughly with a flat stirrer before and during use. Apply two coats by brush, roller or spary equipment. Sand lightly between coat.