Paint - Exterior Paint (Waraprime)
You May Also Be Interested In:
Waraprime is a high opacity water-based primer sealer, it can be applied by either brush, roller or spray prior to the application of the wide range of WARATAH coatings.
Outstanding filling properties
Fast drying formulation
Easy to apply
Flash Point: Non Flammable
Gloss Level: Flat
Solvent Resistance: Moderate when fully cured
Alcohol Resistance: Good when fully cured
Volume Solids: Approximately 35%
Thinning: No thinning required
Drying Times: Touch dry - 30 minutes; Recoat - After 2 hours
Temperature Range: 100 - 350
Coverage: Approximately 10-11 square meters per litre depending upon surface condition
Clean-up: Water, detergent
Package: 15L / Drum
Storage: 18 months in cool and dry place
The surfaces must be clean, dry and free from dust, dirt, grease and oil. Fill nail holes and cracks with appropriate filler and sand smooth. Treat any mould with suitable anti-mould solution.
Previously Painted Surfaces: Sand surfaces thoroughly to remove loose peeling, flaking and chalky paint. Glossy surfaces should be sanded prior to painting.
Bare Plaster: Ensure surface is cured and non-alkaline and all joints are sanded smooth before painting.
Fibro, Brick, and Cement Render: Remove all loose material by rubbing down with a hard block, then dust off. Allow one month for new concrete cure before painting.
Stir thoroughly with a broad flat stirrer using a circular lifting action. Apply one coat of Waraprime by brush, roller or spray. Lightly sand before applying finishing coats. Do not apply at temperatures below 100 or when humidity is very high.