Sell Paint - Exterior Paint (Warashield)

Paint - Exterior Paint (Warashield) You May Also Be Interested In: brush roller exterior paint fibre cement fibrous plaster painted surfaces
Product Description
Warashield is high quality water based 100% acrylic finish designed for the protection of exterior and decorative interior surfaces. It has been formulated with the best quality grade raw materials to enable such high performance. This product dries to a satin finish. It is an ideal material for covering matt texture coatings to improve durability and washability.

Provides a total latex system, offering excellent resistance to blistering on new construction
Excellent adhesion even over chalky surfaces
Screens out harmful ultra violet rays
High elasticity rate 400%
Easy to apply
Quick dry
Minimal odor

Technical Data
Type: 100% Acrylic
Flash Point: Non Flammable
Gloss Level: Approximately 20% measured at 600
Solvent Resistance: Moderate when fully cured
Alcohol Resistance: Good when fully cured
Volume Solids: Approximately 35%
Thinning: No thinning required, but if desired thin sparingly with water
Drying Times: Touch dry - 30 minutes; Recoat - After 4 hours
Temperature Range: 100 - 350
Coverage: One litre will normally cover 3-4. 5 square meters depending upon film thickness and property of the surface

General Data
Clean-up: Water
Colors: Refer to the appropriate WARATAH color card. Colors customer requires are also available
Package: 15L / Drum
Storage: 18 months in cool and dry place

Surface Preparation
Ensure surface is clean and free from dust, dirt and grease. All loose, peeling and flaking material must be removed with a scraper. Sand the surface smooth and remove all dust. Sand enamel painted surfaces until all gloss is removed. Fill holes and cracks with a suitable filler and sand lightly to an even finish.

Preparatory Coats
Previously Painted Surfaces: Over old oil-based enamels use Waraprime undercoat. Over properly prepared water-based finishes no undercoat is required.
Paper-faced Plasterboard: No sealer required. Absorbent plaster joints should have a preliminary coat of Waratah Warshield before coating the entire surface.
Plaster Glass, Fibrous Plaster and Set Hard Plaster: Apply one coat of Waratah Waraprime primer and allow 4 hours to dry.
Unpainted Brick, Cement Render, Stone, Fibre Cement: Ensure that new cement or concrete work is fully cured before applying Waratah Warashield. Alternatively, one coat of Waratah Waraprime may be supplied.

Stir contents thoroughly with a flat stirrer before and during use. Apply two coats by brush, roller or spary equipment. Sand lightly between coat.
Brand Name
Supply Capacity
Totally 60,000,000L/Year
Available Colors
Refer to color card
Condition of Goods
Model Number
Terms of Payment
T/T or L/C at sight
Terms of Sale
FOB Shenzhen