Sell Sell series of jet pumps

Sell series of jet pumps You May Also Be Interested In: centrifugal impeller jet pumps motor protector seal housing thermal cutout
JET PUMPS 77

PERFORMANCE RANGE JET

Flow rate up to 60 l/min

Dynamic head up to 47 m

OPERATING LIMITS

Suction lift up to 9 m

Fluid temperature up to +40 0

Maximum ambient temperature +40 0

A new and improved self-priming
pump design, increased hydraulic
efficiency, to current standards

WORKING PRINCIPLE
The JET series are SELF-PRIMING CENTRIFUGAL PUMPS. Self-priming is achieved using an ejector, housed in the pump body. The total delivery produced by the closed centrifugal impeller is sent only party to the delivery opening. The remaining water is recalculated through the ejector, which is connected to the suction chamber and generates the necessary vacuum of self-priming the pump. When first starting the pump is started up the water, without bothering to fill the section piping and eliminate any air pockets. When the pump is started up the water in the pump body circulates through the ejector and transfers any air from the suction to delivery chamber, expelling it through the delivery piping. At the same time the vacuum thus generated causes water to rise in suction piping, thus self-priming the pump. Since the self-priming system operates continuously, these pumps are practically unaffected even by the presence of large amounts of entrained air in the fluid being pumped. The JET series, based on past TOP experience, is designed with particular attention to hydraulic efficiency and choice of materials. The result is a compact, quiet high performance pump

PUMP INSTALLATION AND APPLICATIONS
These pumps are suitable for pumping clean water and fluid which are not chemically aggressive to pump components.

THEY ARE EXTREMELY RELIABLE, ECONOMICAL AND SIMPLE TO USE, BEING PARTICULARLY SUITABLE FOR DOMESTIC APPLICATIONS SUCH AS THE AUTOMATIC DISTRIBUTION OF WATER FROM SMALL AND MEDIUM-SIZE TANKS, WATERING GARDENS, ECT.

These pumps should be installed in a covered area, protected against the weather.

PERFORMANCE
The wide range of pump in the JET series satisfied the most varied the most varied requirement with features such as:

- high heads with respect to power required;

- flat operating and power absorption curves, giving moderate curve variations with respect to large variations in delivery demand;

- high tolerance of the presence of entertained air the fluid to be pumped;

suction capacity up to 9 meters

STRUCTURAL CHARACTERISTIC

 Cast iron PUMP BODY

 Stainless steel PUMP BODY COVER serving also as mechanical seal housing.

 Techno polymer EJECTOR UNIT (approved for drinking water) centrifugals

 Centrifugal radial flow IMPELLER in BRASS or techno polymer (approved for drinking water) on request.

 Ceramic and graphite MECHANICAL SEAL.

 MOTOR: the pumps are coupled directly to an asynchronous, high efficient TOP induction motor of suitable size, which is quiet running, closed and externally ventilated, suitable for continuous duty. INSULATION class B. The thermal cutout relay (motor protector) is incorporated in all single phase motors. Three phase motors require an adequate external motor protector, with connection according to current standards.

 PROTECTION IP 44

 CONSTRUCTION AND SAFELY STANDARDS in compliance with IEC.

WARRANTY: 1YEAR (according to our general sales conditions)
Supply Capacity
20,000 units per month
Certifications
ISO9001,2000,CE ,UL
Power Requirements
for customer's requirement