Sell Y50EX Series Electric Connector

Y50EX Series Electric Connector You May Also Be Interested In: bayonets circular connector connector electric connector electric iron
Conform to GJB598A-96 standard. With reference to the American MIL-C-26482 standards. They are equailvant to JY series, YB series and MS series, MS series. They can cooperate in use with the receptacles which have the same type. This series connectors are quick coupled by bayonets. Their contacts are soldered. They have merits such as little volume, high density, good resistance to the environment, good reliability and so on advantages. They are widely used in aviation, aerospace, navigation, wild communication, and the electric lines connections of electronic equipments such as the managing system of mail and railroad.

conditions of use environment
Relative temperature: -55 degree - +125 degree
Relative Humidity: when40 +/- 2 degree, up to90% - 95%
Operating Pressure: 101 - 0.8kpa
Sin Vibration: 101 - 2000HZ, acceleration 196m/s2
Collision: acceleration 392m/s2
Impact: acceleration 980.7m/s2
Insulation resistance: under normal atmospheric conditions not less than 3000M(Ohms)
Under the conditions of high temperature of not less than 3M(Ohms)
Humid conditions is not less than 100M(Ohms)
Resistance Temperature: 1500V exchange
Airtightness: General socket is not more than 6 W 10-2Pal/s
Socket sintered glass not more than 1 W 10-5Pal/s
Life expectancy: more than 500 times
Implementing standards : Q/321283LSB04-2006 Y50 series of circular connector.
Operating manners

1, when the corresponding 2 parts of the connectors connect by within bayonets, rotate bayonet cap to the right direction. When inserting safely, and bayonet in the place of the connecting is locking, a white bayonet pin can be seen through the observation hole on the circle of the connecting bayonet cap.
2, wires of the connector should be corresponding to the contact NO. , welding time can not exceed three seconds, electric iron shall not exceed 45W.
3, welding-type connector after welding, the plywood or the wire-protecting covering of the electric coat should nip tightly.
4, When 2 parts of the connector have to insert for a long-term such as storage and use, the safety hole on the connector will be wire linked and nipped tightly with the receptacle.
5, After separation of the two parts of the connectors, the two parts have to cover a dirty-Shield or to be plugged to a empty receptacle. )
6, no inserting of the pin with receptacle.
7, connector installation, the use of staff should understand performance and usage of the connector.
Before un-tightly locking, prohibits using, when there is electric charge, prohibit the separation.

cooperating relations between plugs and sockets
A, when plug and receptacle couple with each other, if plugs install pins receptacles should install holes, the same to the opposite.
B, plug and receptacle should have to choose a shell with same oil painting on its surface, precedent choosing color is black, army green or nickel plating.