Sell pu coating jot88

pu coating jot88 You May Also Be Interested In: bath pool polyurethane sealant pool fountain pu coating waterproofing membrane
Testing Items 2. Performance
Appearance Red, Green, Gray, White, Black, etc.
Density(g/cm3) 1.3510.5
Sagging properties (mm) Self-leveling
Tensile strength (Mpa) >=2.45
Elongation at break(%) >=600
Volatile content(%) <=6
Touch dry time(min) <=120
Pollution properties Non
Application temperature(0) +5~+35
Shelf life(month) 9

1. All data above ware tested under standardized condition.
2. All data listed in the chart were series; please refer to the related datasheet for special items.
3. Storage condition has a direct impact to the products shelf life, Please refer to the instruction for special items storing.

Jot88 is is a kind of coating made by pure polyurethane . It is applied on substrates, to form a firm, soft and seamless sealing film by chemical reaction with moisture in the air. Jot88 is manufactured in accordance with the GB/T19250-2003.

3. USES:
Waterproof for basement, kitchen, bathroom, underground tunnel.
 Leak-proofing and penetrating-proofing of Reservoirs, water towers, swimming-pool,
 Bath-pool, fountain pool, sewage cleaning pool, and irrigation channel.
 Used for preventing of leaking, corrosion and penetrating for water tanks, underground
 Bonding and moisture-proofing of various, floor tiles, marble and so on.

Clean and dry all surfaces by removing foreign matter and contaminants such as oil dust, grease, frost, water, dirt, old sealants and any protective coating. Dust and loose particles should be cleaned.

700g sausage, 20kg/bucket

The substrate should be smooth, solid, clean, dry without sharp concave and convex points, honeycomb, pocking marks, peeling, free of bulges, greasy before application. it is better coating 3 times with scraper. When the first coat isnt sticky, the second coat can be applied, the first layer is recommended being applied in thinner layer for better releasing gas generated during reaction. The second coat should be applied in different direction to the first coat. The optimal coating rate is 2.0kg/m2 for thickness of 1.5mm.

Pure polyurethane sealant, environment-friendly.
Contains no asphalt, tar or any solvents, no harm to construction personnel.
Easy for applying.
Free from pollution to the environment, No toxity after curing, No corrosion to base material, High solid content.
One component, convenient for construction, No need of mixing.
All items tested exceeds nation standard GB/T19250-2003.

Jot88 should be inverted in dry and shady indoor, avoid sunlight
and moisture.
It is normally that a film formed on the surface of coating. It can be
used normally when removing the film.
The rest coating should be sealed in order to avoid moisture.
Pay attention to protect the waterproofing membrane during constructing
period and after finished.
Warehouses and construction of the site is strictly prohibited fireworks.